Carpet Outdoor

carpet indoor outdoor

By Rednallog Anconformity

You need to consider where you are going to put your outdoor carpet. There are many different types of outdoor carpet that available on the market whether it is for your porch, deck, or patio. Olefin is the basic material from an outdoor carpet. The simplest version of this kind of carpet that you will find is the Astroturf-like grassy material, well-known from stadiums and such. And the next step up is higher quality grass-like olefin base outdoor carpeting, which is more moisture resistant and generally much better in areas subject to lots of passing and other heavy use. And then the other big family of outdoor carpets is based on imitating indoor styles, but adding waterproofing. The materials are mostly synthetic, but plant-based or woolen outdoor carpets also exist. Nowadays there are a wide selection of both colors and textures from the very plush to the basic. You can choose varying grades of carpet. And to install your outdoor carpet, have a look at the tools you will need. You will need items like utility knife, carpet roller 50 lb, double faced carpet tape, etc.

First, prepare your surface and unroll the carpet. Take your two sided double tape and place the tape around the outer edge of the room on the sub floor. Leave the protective paper on the top side of the tape so as not to loose the adhesion. Next, center the carpet in the room. Position it so the edges are able to curl up against the wall. Allow at least 3″ on each side. You can trim excess away later. Then trim around protrusion and outside corner edges by making a vertical slice down the carpet. To fit your carpet on inside corners you need to do a V cut where it over laps. Move slow and carefully when making these cuts so that you do not cut too far. If your room needs to be seamed be sure you have the pile running in the same direction so that the seam is the least noticeable. To make a double cut seam take your straight edge and utility knife and cut through both layers at exactly the same time using the tools together. Start against the wall and then fold the carpet back half way but don’t move the half that still down. If you are doing a permanent installation this is when you will use your adhesive. Take a notched spreader, apply adhesive, and then apply the adhesive to the sub floor. Follow instructions on the adhesive. Now slowly roll the carpet you rolled back earlier back into place. Smooth out any bumps and make sure you’ve got it lined up properly. If you were careful rolling it back all should be fine. Repeat the entire process above for the other side of the room now. Now take your carpet roller and run it across the entire carpet to get the adhesive to properly adhere all over the carpet. Now is the time to use that sharp utility knife and trim away the excess on the edges around the outside of the room. Now is the time to clip any threads you see as well so that they don’t start to unravel. Clean away any excessive adhesive using a mild solvent. Follow the instructions provided by the manufacturer. Connect the dots or in this case connect the rooms. If you are laying outdoor carpet in more than one room use metal binder strips to cover the join.